基于滑动摩擦胶印机滚筒参数研究.pdfVIP

中国印刷与包装研究 2010年11月（第 2 卷） CHINA PRINTING AND PACKAGING STUDY Vol.02 2010.11 287 基于滑动摩擦的胶印机滚筒参数研究 1 1 2 3 张海燕 ，侯和平 ，司军锋 ，陈晓宇 （1.西安理工大学 印刷包装工程学院，西安 710048; 2.国家知识产权局专利审查协作中心, 北京 100190; 3.上海电气租赁有限公司, 上海 200041） 摘要 胶印接触区中，印版表面相对于橡皮表面存在相对滑动，使印刷图文的尺寸发生变化，对印品质量造 成影响。本文研究了滚筒滚压过程接触区的相对滑动情况，提出了胶印机滚筒几何参数的确定原则。研究表 明，当弹性滚筒半径比刚性滚筒半径大 0.2 倍的压缩量时，相对滑移量最小，图文变形和网点扩大最小，为 精确确定胶印机的滚筒半径提供理论依据。 关键词 相对滑动；滚筒半径；滑动摩擦；胶印机 中图分类号 TS827 Parameter Study of Offset Press Cylinders Based on Sliding Friction 1 1 2 3 ZHANG Haiyan , HOU Heping , SI Junfeng , CHEN Xiaoyu (1.The Faculty of Printing and Packaging Engineering, Xi’an University of Technology, Xi’an 710048, China; 2.Patent Examination Cooperation Center of SIPO, Beijing 100190, China; 3.ShangHai Electric CO, LTD, Shanghai 200041, China) Abstract In the contact area of offset, a relative slide occurs between the surface of plate cylinder and blanket cylinder, which changes the size of print image and influences the printing quality. On the basis of research for the situation of relative slide in the cylinders’ rolling process, the principle on which cylinders’ geometric parameters of offset press are defined is proposed. The results show that the relative slide reaches minimization on the condition that elastic cylinder radius is 0.2 times compression amount bigger than rigid cylinder radius. The deformation of print image and dot gain also reach minimization in the same condition. These results provide theoretical basis for accurate determination of offset press’ cylinder radius. Key words Relative slide; Cylinder radius; Slinding friction;