低碳硅-锰Q%26P钢工艺优化和残余奥氏体的定量研究.pdfVIP

2007 中国钢铁年会论文集 低碳硅-锰 QP 钢工艺优化及残余 奥氏体的定量研究 赵 才*1,2 江海涛 1 唐 荻 1 赵松山 1 李 辉 1 (1. 北京科技大学 高效轧制国家工程研究中心,北京 100083 ； 2. 太原科技大学材料科学与工程学院，太原 030024) 摘 要 在 Gleeble3800 热模拟机上对低碳 Si-Mn 系 QP 钢的热处理工艺进行了试验研究，利用透射电镜进行了微 观组织观察和断裂机理分析。采用 Matlab 软件预测了室温下能获得最大量稳定残余奥氏体的最优淬火温度，采用 VC6.0++软件编程并结合 XRD 技术对残余奥氏体的体积分数进行了定量测定。结果表明：其组织主要由板条马氏 体和8%左右的板条相间残余奥氏体薄膜组成，钢板拉伸时发生典型的韧窝断裂。 关键词 QP 淬火温度 配分温度 板条马氏体 残余奥氏体 Technology Optimization for Low Carbon Si-Mn QP Steel and Quantitative Analysis of Retained Austenite Zhao Cai 1,2 Jiang Haitao 1 Tang Di 1 Zhao Songshan1 Li Hui 1 (1. National Engineering Research Center for Advanced Rolling Technology, University of Science and Technology Beijing, Beijing, 100083; 2. College of Materials Science and Engineering, Taiyuan University of Science and Technology, Taiyuan, 030024) Abstract The quenching and partitioning (QP) process was experimentally investigated on the thermo-mechanical simulator (Gleeble3800). The microstructure and fracture mechanism of the sheets were investigated by means of TEM. It is shown that the microstructure of QP steel is fine lath martensite and thick inter-lath austenite films. The optimum quench temperature to produce the maximum amount of retained austenite after final quenching to room temperature was simulation predicted by Matlab software package. The volume fraction of austenite retained at room temperature is approximately 8%, which was measured easily by the software VC6.0++ programming. It is verified that QP steel Possesses a good co