E951 POWER SUPPLYSAFETY REVIEW90602.ppt

E951 POWER SUPPLYSAFETY REVIEW9/06/02 IOANNIS MARNERIS Brookhaven National Labs. Project Goals The project goal is to pulse a magnet with 15 cm diameter bore, capable of a peak field near 15 T and a repetition rate of about 30 minutes. Provisions are made to pulse first to 5 T, then 10 T and then 15 T. To do this we will use 4 existing SCR type dc power supplies from the experimental area in series-parallel connection. Each power supply is rated at 3600 Adc, +/- 150 V Parameters of the Pulse Magnet System with 1 sec flat top Performance of the 5T magnet with case 1 power supply Performance of the 10T magnet with case 2,3 power supply Performance of the 15T magnet with case 2,3 power supply Case 1 power supply 540 KVA power supply rated at 3600 A, +/-150 V Thyristor-control six-pulse rectifier, available at Brookhaven Labs from previous experiments. (Model Meeker #431) The power supply is presently configured as DC power supply We need a new regulator to be able to pulse it, based on the existing design for the AGS Main magnet power supply. The controls and interlocks of the power supply must be updated. New direct current potential transformer (DCPT). New crowbar circuit to absorb magnet stored energy. Similar upgrades have been made during the Booster project with great success. Case 1 power supply regulator Case 2,3 power supply Four series-parallel, 540 KVA power supplies rated at 3600 A, +/-150 V each, Total rating 7200A, +/-300V. Thyristor-control six-pulse rectifiers, available at Brookhaven Labs from previous experiments. (Model Meeker #431, in parallel with # 433, and #429, in parallel with # 432, ) The power supplies are presently configured as DC power supplies. We need a new regulator to be able to pulse it,based on the existing design for the AGS Main magnet power supply. The controls and interlocks of the power supply must be updated. New direct current potential transformer (DCPT). New direct current current transformer (DCCT). New crowbar ci