rvdm80-Port IntegrationModule.ppt

Port IntegrationModule HCS12 - Port Integration Module HCS12 - Port Integration Module HCS12 Input / Output HCS12 I/O Pins Output Fault Detection: Ability to read pin state of outputs via Input Registers Reduced drive mode: Controlled by Reduced Drive Registersuseful for EMC on SPI lines, PWM, etc. Unused pins on PWB design: Configure as output and leave open, Leave as input and enable pullup/pulldown, Leave as input and tie to gnd. Write data register to 0. Special considerations for 80 pin package: Same die as in 112 pin package. Floating pads on die must be input with pulldown oroutput with driven to 0. Also reference - EB386: “ Family Compatibility Considerations” Transient protection: Limit short duration injection currents to +/- 25 mA Steady State injection currents: Up to 2.5 mA per pin, 25 mA per pkg. HCS12 PIM - Rerouting Port T Registers Port S Registers Port M Registers Port P Registers Port H Registers Port J Registers HCS12 PIM - Rerouting HCS12 Technical Training Module 6 – Port Integration, Slide * MOTOROLA and the Stylized M Logo are registered in the US Patent Trademark Office. All other product or service names are the property of their respective owners. ? Motorola, Inc. 2001. On the HCS12 each port has a set of control registers (in the PIM) arranged in a similar structure where each individual I/O pin can be configured for: ? Input/output selection (Ports T,S,M,P,H,J ) ? Drive strength reduction ? Enable and polarity of pull resistors ? Interrupt enable and status flags A standard port has the following minimum features: ? Input/output selection by bit. ? 5V output drive with two selectable drive strengths ? 5V digital or interrupt inputs ? Input with selectable pull-up or pull-down device Optional features: ? Open drain for wired-or connections (Ports S,M) ? Interrupt inputs with glitch filtering (Ports P,H,J ) Interrupt polarity Port A, B, E and K are part of the core, not part of PIM. Port Input Registers can be used to dete