局部热处理对钢-钛自冲铆接头力学性能的影响.pdfVIP

·120· 材料导报B：研究篇 局部热处理对钢-钛自冲铆接头力学性能的影响+ 卢 毅，何晓聪，王医锋，刘福龙，张越 (昆明理工大学机电工程学院，昆明650500) 摘要 对钢一钛自冲铆接头进行局部热处理，并对已热处理和未热处理的接头进行拉剪实验，对比分析局部热 处理对钢一钛自冲铆接头的静强度、能量吸收、失效模式和失效机理的影响。结果表明：淬火对钢一钛自冲铆接头的静 强度有很大提高作用，对其能量吸收有减小作用；未淬火的钢一钛自冲铆接头失效模式为上板与铆钉分离且上板被撕 裂，上板的断口形貌为典型韧性断裂特征；淬火后的钢一钛自冲铆接头失效模式为上板与铆钉分离且铆钉被拉断，铆 钉的断口形貌为典型的沿晶断裂特征。 关键词 自冲铆钛合金热处理拉剪实验断口形貌 中图分类号：T0447文献标识码：A 2015．10．028 DOI：10．11896／j．issn．1005-023X Effectof LocalHeatTreatmentontheMechanical of Properties Riveted Joints Self-piecing LUYi，HE Yue Xiaocong，WANGYifeng，LIUFulong，ZHANG ofMechanicalandElectrical ofScienceand 650500) (Faculty University Engineering，Kunming Technology，Kunming AbstractLocalheattreatmentwasusedtotreatthe riveted tensile steebtitanium(S-T)self-piecingjoints，the sheartestwas totestthetreatedandnottreated effectofthelocalheattreatmentonthestatic applied joints，and modeandfailuremechanismoftheS-T were joints analyzed．The strength，energyabsorbing，failure comparatively resultsshowedthatthe ofthe was static ofthe was strengthjointsimprovedbyquenching，theenergyabsorbingjoints reduced failuremodeoftheS-T not wasthe sheet fromthe byquenching．The jointsbeingquenchedupper separat