CVI_RMI法制备C_SiC复合材料的微观结构与弯曲性能.pdf

38 3 () Vol.38 No.3 2007 6 J. Cent. South Univ. (Science and Technology) Jun. 2007 CVI-RMI C/SiC ( 410083) T700 CVI -(CVI-RMI)C/SiC CVI-RMI C/SiC (10%) 133 MPaCVI-SiC RMI C/SiC TB332 A 1672-7207(2007)03−0381−05 Microstructure and flexural properties of C/SiC composites by CVI-RMI method XIAO Peng, XIE Jian-wei, XIONG Xiang, YAN Zhi-qiao (State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China) Abstract: Pyrolytic carbon coating and successive SiC matrix were respectively prepared by chemical vapor infiltration (CVI) in T700 kind integer felt. The subsequent reactive melt infiltration (RMI) method was adopted to densify it further and C/SiC composites were successively prepared. The microstructure and effect of interface on flexural properties were thoroughly investigated. The results show that C/SiC composites fabricated by CVI-RMI methods have high density and low porosity(10%), in which CVI-SiC and RMI-SiC distribute uniformly. The flexural strength of the composites is 133 MPa. The composites are damaged layer by layer with good pseudo-plasticity. C fibers are damaged lightly because of pyrolytic carbon coating and CVI-SiC. Pyrolytic carbon coating moderates the interface strength between C fibers and SiC, which is beneficial to the pulling out of C fibers. Key words: C/SiC composite materials; microstructure; chemical vapor infiltration; reactive melt infiltration; flexural properties (CMCs) SEP C/SiC [6−8] (CVI) CMCs [1−5]