裤衩腿循环流化床_翻床_过程影响因素的研究.pdfVIP

30 12 动 力 工 程 学 报 Vol. 30 No. 12 2010 12 Journal of Chinese Society of Pow er Engineering Dec. 2010 : 1 747 07(2010) :TK229. 2 :A :470. 30 1 1 1 2 1 杨志伟 , 王 哲 , 李 政 , 孙纪宁 , 倪维斗 ( 1. , , 100084; 2. , , 100084) : 利用所建立的裤衩腿循环流 床动态数学模型, 对 翻床 过程的原因及主要影响因素进 行了分析. 结果表明: 选用对压力变 相对稳定的罗茨风机并保证其工作在稳定工况区以及在合理 范围内降低床料压降占炉膛总压降的比例, 均有利于控制 翻床 现象的发生; 两侧较大的温度偏差 也有可能导致两床发生失稳, 运行时应尽量保持炉膛两侧床温一致. : 循环流 床; 裤衩腿; 模型; 翻床; 床料压降 Factors Influencing Bed Turning Process of Circulating Fluidized Bed w ith Breecheslegs 1 1 1 2 1 YA N G Zhiw e i , WA N G Zhe , LI Zheng , S UN J in ing , N I Weidou ( 1. State Key Lab of Pow er Systems, Department of T hermal Engineering, Tsinghua U niversity, Beijing 100084, China; 2. National Key Lab of Science and Technology on AeroEngines, School of Jet Propulsion, Beijing U niversity of Aeronautics Astronautics, Beijing 100084, China) Abstract: Causes and main influencing factors of the bed turning process w ere analyzed by the built up dynamic mathematic model for the circulating fluidized bed ( CFB) w ith breecheslegs. Results show that selecting Root! s fan w ith little sensitivity to pressure variation and keeping the fan operating in stable con dition, as w ell as deceasing the ratio of bed pressure drop to total pressure drop in the furnace are in favour of avoiding the bed turning phenomenon. Large temperature difference betw een the tw o sides of furnace may result in bed turning , so the bed temperatures of the tw o sides should be kept consistent during op eration. Key words: circulating fluidized bed; breecheslegs; model; bed turning; bed pressure drop Alstom 300 MW