a simple emi filter design method for communication power supplies.pdfVIP

A Simple EMI Filter Design Method in Communication Power Supplies Lian Yuxin, Yang Shiyan, Wu Jianqiang and Li Haoyu Electrical Engineering Department, Harbin Institute of Technology, Harbin , 150001 China Abstract This paper presents an improved and simplified significant impact on the attenuation of the EMI filter and method to design electromagnetic interference EMI filters for EMI filter should be designed to match noise source communication power supplies. Based on the measurement of impedance. According to the method in [3], the maximum the maximum and the minimum differential mode DM and and minimum CM and DM noise source impedances of main common mode CM EMI noise source impedance, a method is points we concerned at the frequency range. The proposed to suppose the noise source as current source and calculate the magnitude of DM and CM noise source current. measurement steps are summarized below. In the Then EMI filter is designed according to the magnitude of noise measurement, a power combiner is used to separate CM and source current. The proposed method is easy to apply in DM noise spectrum from the total line noise spectrum. [5] practice without considering the topology and control method Step 1: Without any filter, to measure CM noise signals of of the power supply. The calculated and experimental results of power supply at some points we concerned such as switching a 600W prototype show the method is feasible to guarantee to satisfy requirement, especially at low frequency. frequency point first, by using HP8591 EMC spectrum analyzer and 0 degree power combiner, as Fig.1 shows. The I. INTRODUCTION blue line is the quasi-peak values of EN550022 Class B regulation , and the brown line is the average values. COMMUNICATION power supplies in communication CM Noise dBuV system s, are used to convert the input voltage to a lower 120.18 140 voltage. Generally speaking,