CanInAutomation_Cabling and connector pin assignment.pdfVIP

CiA Draft Recommendation 303 Additional specification Part 1: Cabling and connector pin assignment Version: 1.7 15 December 2009 ? CAN in Automation CiA e. V. Additional specification – Part 1: Cabling and connector pin assignment HISTORY Date Changes 1999- 10- 10 Publication of Version 1.0 as draft recommendation 2004-09-01 Publication of Version 1.2 as draft recommendation 2004- 12-30 Publication of Version 1.3 as draft recommendation 2006-08- 14 Publication of Version 1.4 as draft recommendation 2007-06-08 Publication of Version 1.5 as draft recommendation 2008-06-03 Publication of Version 1.6 as draft recommendation 2009- 12- 15 Publication of Version 1.7 as draft recommendation - editorial clarifications - adding 8-pin Ampseal connector - adding a reference for 18-pin VDA interface connector - adding a reference for 2-pin power connector General information on licensing and patents CAN in AUTOMATION CiA calls attention to the possibility that some of the elements of this CiA specification may be subject of patent rights. CiA shall not be responsible for identifying any or all such patent rights. Because this specification is licensed free of charge, there is no warranty for this specification, to the extent permitted by applicable law. Except when otherwise stated in writing the copyright holder and/or other parties provide this specification “as is” without warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. The entire risk as to the correctness and completeness of the specification is with you. Should this specification prove failures, you assume the cost of all necessary servicing, repair or correction. Trademarks CANopen? and CiA? are registered trademarks of CAN in Automation. The use is rest