D297-rubberproductschemicalanalysis.pdfVIP

Designation: D 297 – 93 (Reapproved 1998) AMERICAN SOCIETY FOR TESTING AND MATERIALS 100 Barr Harbor Dr., West Conshohocken, PA 19428 Reprinted from the Annual Book of ASTM Standards. Copyright ASTM Standard Test Methods for Rubber Products—Chemical Analysis1 This standard is issued under the fixed designation D 297; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope D 1416 Test Methods for Rubber from Synthetic Sources— 1.1 These test methods cover the qualitative and quantita- Chemical Analysis3 tive analysis of the composition of rubber products of the “R” D 1418 Practice for Rubber and Rubber Lattices— Nomenclature3 family (see 3.1). Many of these test methods may be applied to the analysis of natural and synthetic crude rubbers. D 1646 Test Method for Rubber—Viscosity, Stress Relax- 1.1.1 Part A consists of general test methods for use in the ation, and Pre-Valcanization Characteristics (Mooney Vis- determination of some or all of the major constituents of a