多模式开关电源制器设计.pdfVIP

Subject : Design of Multi-Mode Switching Controller Speciality : Microelectronics and Solid-State Electronics Name : Liu Jie (Signature) Instructor : Liu Shu-lin (Signature) ABSTRACT As the development of economy and progress of scientific, our society focuses more and more attention on saving energy. Governments and industry associations make energy standards to conform to this trend. The laws and regulations to restrict the maximum power of ususlly consumer electronic devices in standby and load mode.Not only to save energy, but also to satisfy relevant regulations, it is singnificant to make a study of reducing power loss. In this article, the system composition of flyback converter, working principle and switching power loss were studied firstly. Then three modulation modes and peak current control modes of the switching power supply are analyzed. Compared with PWM, PFM has smaller power losses under light load. The control signal shields off part of the clock cycle under the BURST mode, which reduces power losses in standby. In order to reduce power loss and improve transforming efficiency, a switch controller is designed based on muti-mode automatic switching technology. The circuit is modularized according to the functional needs and design requirements, and every partial module of the circuit is separately designed and simulated. The total circuit is simulated with the simulation software spectre of the tool Cadence under 0.5 um BCD process model. Simulation results show that the working mode of the chip is shifted according to the feedback voltage: When the VFB 0.4V,the chip works in cycle mode; When 0.4VVFB1.2V, the chip works in PFM mode; When the VFB1.2V, the chip works in PWM mode. The simulation results