Word-ColoradoHardscapes.docVIP

Custom Polishing Systems VitraFlor by Bomanite Guideline Specification Deep Grind Application SECTION 033000 CAST-IN-PLACE CONCRETE PART 1– GENERAL 1.1 RELATED DOCUMENTS A. Drawings and general provisions of the Contract, including General and Supplementary Conditions and Division 1 Specification Sections, apply to this section. 1.2 SUMMARY A. Work specified in this section includes all labor, materials, equipment and services necessary to complete the VitraFlor by Bomanite Custom Polishing System including curing compounds, appropriate suface preparation, concrete densifiers and stain-resistant treatments. B. Related Sections include the following: 1. Division 1 Section 揚roduct Requirements?for submittals and substitutions.er3. Division 3 Section 揓oint Sealers?Installation of caulking. 1.3 SUBMITTALS onA. Environmental Limitations: 1. Comply with manufacturer’s written instructions for substrate temperature and moisture content, ambient temperature and humidity, ventilation and other conditions affecting installation performance. 2. Concrete must be cured a minimum of 28 days or as directed by the manufacturer before application of Bomanite Custom Polishing can begin. B. Close areas to traffic during and after floor application for time period recommended in writing by licensed installer. PART 2 - PRODUCTS 2.1 MANUFACTURERS A. In other Part 2 articles where titles below introduce products, the following requirements apply to product selection: 1. Available Manufacturers: Subject to compliance with requirements, manufacturers offering materials decorative in nature required to be incorporated into the work include, and are limited to, manufacturer listed. a. Colorado Hardscapes 8085 E. Harvard Ave Denver, CO 80231 Tel: (303) 750-8200 Fax: (303) 750-8886 2.2 MATERIALS A. Bomanite S