cdma_ms_measure.ppt

01/99ppt Introduction to CDMA Mobile Testingb.ppt Introduction to CDMA Mobile Testing With the E8285A CDMA Mobile Station Test Set Third Edition CDMA Test Overview Whats Different About CDMA ? The IS-98-A TIA standard Service Options Transmitter Tests Receiver Tests Functional Tests Whats Different with CDMA?  Powerful Error Correction Codes are Used On All Voice Data Bits Processing Gain Makes CDMA Tolerant of Transmission Errors New Modulation Format Requires A New Figure of Merit for Waveform Quality Since CDMA is Designed to Work in a High Interference Environment, Testing Must Simulate Interference Conditions The IS-98-A Minimum Performance Standard Standard for Dual-Mode Wideband Spread Spectrum Cellular Mobile Stations Developed through the Telecommunications Industry Association TR45.5 Working Group Important Test Sections of IS-98-A: Section 2 - Analog Receiver Standards Section 3 - Analog Transmitter Standards Section 9 - CDMA Receiver Standards Section 10 - CDMA Transmitter Standards Service Options Service Option 001 is Voice Mode Service Option 002 is 9600 bps Data Loopback Mode Service Option 009 is 14400 bps Data Loopback Mode Service Option 002 is Specified for Nearly All IS-98 Tests Provides a Convenient Method of Testing Mobiles Under Over-The-Air Transmission Conditions Data Received From the Base Station Simulator is Retransmitted by the Mobile Under Test Getting a CDMA Mobile On A Simulated Link To Establish a Simulated Link, A Base Station Simulator Needs to: Provide a Pilot Channel for Short Code Timing and Frequency Reference Transmit a Sync Channel to Provide System Time (Fine Synchronization) Call the Mobile via a Paging Channel Requesting Service Option 002/009 (Mobile Auto Answers) Direct the Mobile to a Traffic Channel Pass Protocol Messages to the Mobile On the Traffic Channel Maintain the Link During Required Measurements Base Station Simulator HPs CDMA Mobile TestSolution: The E8285A The E828