加纳布维水电站土石坝心墙料碾压工艺参数的分析与选择.docVIP

  • 5
  • 0
  • 约4.15千字
  • 约 7页
  • 2016-03-02 发布于北京
  • 举报

加纳布维水电站土石坝心墙料碾压工艺参数的分析与选择.doc

加纳布维水电站土石坝心墙料碾压工艺参数的分析与选择.doc

加纳布维水电站土石坝心墙料碾压工艺参数的分析与选择   摘要:本文对国际水电工程加纳布维(EPC)水电站项目1#副坝(土石坝)的心墙料碾压工艺试验的现场情况进行了介绍,对该土石坝所采用的心墙料取土场的料源性质进行了必要的室内试验,通过分析介绍了粉砂、砾石和粘土混合料(以下称为土料)作为芯墙的碾压试验结果。本文着重介绍了该料场土料的碾压工艺试验过程和参数分析与选择。包括对碾压控制参数范围的选择、设备选型、场地布置、碾压顺序和试验成果分析等,展示了本工程心墙料碾压工艺试验的全过程,并通过分析得出碾压施工所采取的参数值。   关键词:土石坝;心墙料;参数;碾压;选择;布维   Abstract: This paper introduced on International Hydropower Project Garner Bouvet ( EPC ) Hydropower Station Project 1# auxiliary dam ( dam ) of the heart wall rolling process testing field, take the necessary the indoor test for the earth-rock dam with core wall material soil source material properties are, through the analysis of introduced silty sand, gravel and clay mixture ( hereinafter referred to as the soil material ) as the core wall of the compaction test results. The paper introduces the material field soil compaction technology of test process and parameter analysis and selection. Including the control of compaction parameters selection, equipment selection, site layout, rolling sequence and analysis of test result, showing the project core material and rolling process in the whole testing process, and through the analysis of the roller compaction construction taken by the parameter value.   Key words: earth-rock dam; core wall material; parameter; rolling; selection; Bouvet   中图分类号:TV5   一、工程概况   非洲加纳布维水电站1#副坝为土质心墙堆石坝,坝顶高程EL.187.00m,坝顶宽8m,最大坝高53m。芯墙料料场位于1#土石坝下游侧区域,距1#土石坝距离约500m左右。由于料场土层相互交错分布,其中粉土质砂厚约0.5-1.0m,呈浅黄色-淡紫色,砂含量一般占55%-60%;粘土质砾砂厚约0.5-1.5m,呈褐黄-浅棕色,砾粒径一般为0.3-5.0cm,含量占25%-30%不等,砂含量约占40%左右;粘土厚0.4-1.4m,呈土黄、褐黄、浅棕等混杂色。由于料场土层分布不均,该土石坝采用粉土质砂、粘土质砾砂及粘土混合料作为芯墙料。为确定芯墙料的压实特性,进行了不同铺料厚度、碾压遍数和不同含水率的现场碾压试验。通过不同压实条件下心墙料的干密度、压实度、渗透系数、含水量的综合分析,最终确定坝体心墙填筑料的碾压参数值。    二、心墙料设计要求   渗透系数?1×10-5cm/s,最大干密度≥18.7KN/m3,压实度≥99%,压实后层厚?0.3m,可溶盐含量小于3%和有机质含量小于2%,最大粒径?5mm。    三、土料室内试验   通过对取土场的具有代表性的土料进行室内试验,结果如下表:   表1-土料场物理力学试验表            由上表可得:天然含水量ω为5.5%~14%,平均值为8.77;塑性指数IP为5~19.9,平均值为12.32;黏土(?0.075mm)含量为29%~61.4%,平均含量为44.8%;最大干密度为1.77g/cm3~2.031g/cm3,平均值为1.93 g/cm3;最优含水量为9.4%

文档评论(0)

1亿VIP精品文档

相关文档