introduction to electronic circuit design.pptVIP

下载本文档

10
0
约2千字
约 22页
2016-03-05 发布于广东
举报
版权申诉

introduction to electronic circuit design.ppt

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

introduction to electronic circuit design

IntroductiontoElectronic Circuit Design Richard R. SpencerMohammed S. Ghausi Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ?2003, Pearson Education, Inc. Chapter 11, slide * Figure 11-1 Ideal filter transfer function: (a) low-pass, (b) high-pass, (c) bandpass, (d) bandstop (or notch), and (e) allpass. Figure 11-2 (a) The Bode magnitude plot and (b) phas plot for an ideal low-pass filter with cutoff frequency wc = 1 rad/s and delay tp = 1 s. (c) The impulse response of the filter and (d) the step response. Figure 11-3 The pole locations of a Butterworth transfer function with N = 4. The poles are equally spaced around the left half of a unit circuit and are symmetric about the real axis. Figure 11-4 The Butterworth magnitude responses for N = 1, 2, 3, and 4. Figure 11-5 Specifications for a low-pass filter. A transfer function that meets these specifications is also shown. Figure 11-8 Magnitude and phase of the standard second-order transfer function for Q = 1, 0.707, and 0.3. Figure 11-9 The Chebyshev magnitude responses for N = 3 and 4 with e = 0.509 (a 1-dB ripple). The frequency is normalized to the edge of the ripple band, instead of the cutoff frequency. Figure 11-11 (a) Ideal bandpass characteristics. (b) Practical bandpass characteristics. Figure A11-1 (a) A message signal and (b) the resulting amplitude-modulated signal. Figure 11-16 (a) Low-pass pole location. (b) Corresponding bandpass pole locations found using the narrowband low-pass-to-bandpass transformation. Figure 11-18 The Butterworth bandpass magnitude response. Figure 11-19 A feedback amplifier with a frequency-dependent feedback network. Figure 11-22 An RC integrator. Figure 11-23 A switched-capacitor integrator. Figure 11-24 (a) The switched-capacitor integrator. (b) The nonoverlapping clocks. Spencer/Ghausi, Introduction to Electronic Circuit Design, 1e, ?2003, Pearson Education, Inc. Chapter 11, slide *