混凝土单轴抗压强度三维细观数值仿真.pdfVIP

31 卷 3 期 Vol.31 No.3 工 程 力 学 2014 年 3 月 Mar. 2014 ENGINEERING MECHANICS 39 文章编号：1000-4750(2014)03-0039-06 混凝土单轴抗压强度三维细观数值仿真 1 2 2 3 王 娟 ，李庆斌 ，卿龙邦 ，管俊峰 (1. 郑州大学水利与环境学院，河南，郑州 450001；2. 清华大学水沙科学与水利水电工程国家重点实验室，北京 100084 ； 3. 华北水利水电学院土木与交通学院，河南，郑州 450011) 摘 要：该文在细观层面上将混凝土看作粗骨料、砂浆、界面、初始缺陷组成的四相复合材料，给出了三维随机 缺陷界面弹簧元模型模拟混凝土单轴抗压强度的数值方法。讨论了初始缺陷含量及其分布的确定方法以及界面细 观计算参数的取值范围。数值模拟结果表明：混凝土的抗压强度随着初始缺陷含量的增加有大幅度降低；当界面 初始缺陷含量为30%时，混凝土抗压强度的计算值与试验值吻合较好。 关键词：混凝土；初始缺陷；界面弹簧元模型；单轴抗压强度；数值仿真 中图分类号：TV43 文献标志码：A doi: 10.6052/j.issn.1000-4750.2012.10.0768 3D SIMULATION OF CONCRETE STRENGTH UNDER UNIAXIAL COMPRESSIVE LOAD 1 2 2 3 WANG Juan , LI Qing-bin , QING Long-bang , GUAN Jun-feng (1. College of Water Conservancy and Environment Engineering, Zhengzhou University, Zhengzhou, Henan 450001, China; 2. State Key Laboratory of Hydroscience and Engineering, Tsinghua University, Beijing 100084, China; 3. School of Civil Engineering and Communication, North China Institute of Water Conservancy and Hydroelectric Power, Zhengzhou, Henan 450011, China) Abstract: An interfacial spring element model (ISEM) is employed to simulate the strength of concrete under uniaxial compressive loading. In this model, the concrete was considered as a composition consisting of aggregate, matrix, interfacial transition zone (ITZ) and initial defects in ITZ at meso level. The distribution and contents of the initial defects, and the ITZ properties parameters are discussed, accordingly which, the range of meso-parameters are sugges