带端柱高性能混凝土剪力墙非线性分析及其轴压比限值研究.pdfVIP

第 28 卷第 1 期 Vol.28 No.1 工 程 力 学 2011 年 1 月 Jan. 2011 ENGINEERING MECHANICS 171 文章编号：1000-4750(2011)01-0171-07 带端柱高性能混凝土剪力墙非线性分析及其 轴压比限值研究 *杨鹏辉，梁兴文，邓明科 (西安建筑科技大学，陕西，西安 710055) 摘 要：带端柱高性能混凝土剪力墙构件具有良好的抗震性能。然而我国规范中，对这种结构的轴压比限值没有 给出相应的条文。在工程实践中，设计人员只能套用普通混凝土剪力墙的相关规定，不尽合理。在 6 片带端柱高 性能混凝土剪力墙抗震试验分析的基础上，采用结构三维非线性静力/动力分析程序 CANNY，建立了带端柱高性 能混凝土剪力墙的力学模型，数值模拟了试件在反复水平加载作用下的受力和变形过程。采用试验研究与数值模 拟相结合的方法，研究了带端柱高性能混凝土剪力墙的轴压比限值，为修订规范和工程设计提供参考。 关键词：高性能混凝土剪力墙；非线性分析；轴压比限值；端柱；力学模型 中图分类号：TU398.2; TU311.4 文献标识码：A NON-LINEAR ANALYSIS AND STUDY ON ALLOWABLE AXIAL LOAD RATIO OF HIGH-PERFORMANCE CONCRETE SHEAR WALL WITH BOUNDARY COLUMNS * YANG Peng-hui , LIANG Xing-wen , DENG Ming-ke (Xi’an University of Architecture and Technology, Xi’an, Shaanxi 710055, China) Abstract: High-performance concrete (HPC) shear wall with boundary columns has good seismic behavior. However, the relevant provisions on allowable axial load ratio for this structure are not given in Chinese code. In current engineering practice, the relevant regulations for common concrete shear wall are used by designers although it’s unreasonable. Based on the seismic experiments of six HPC shear walls with boundary columns, the mechanical model was established and the experimental process was numerically simulated under the repeated horizontal loads by using the 3-Dimensional Non-linear Static/Dynamic Analysis Program CANNY. By combining the experimental research and the numerical simulation, the allowable axial load ratio of HPC shear wall with boundary columns is investigated and discusse