hinge design concept详解.pptVIP

Clip structure (RMP supplier hinge) Clip structure (RMP supplier hinge) Clip structure (RMP supplier hinge) Other design considerations iron tablets should be noted (A) Other design considerations iron tablets should be noted (Two)Processing time is larger than the aperture when the handle thick mandrel punching more difficult to Other design considerations iron tablets should be noted (Three)Riveting rivet holes with iron piece mandrel end of the stay required to keep the aperture aperture1.21.2Times safer Latchness Hinge Design Concept Non-Latch Design Concept Hinge Structure and principle: : The construction industry currently usedCam type,The role of the cam falling coincidence ,Produce Auto Lock Gong Can ,General angle set to fall 7-8Degree,The current structure of the common problems ,For the design ,Because Cam actuated ,Will produce a large force of climb out (WhenAFor0.25 ~ 0.30 mmWhen,AboutTorque The 1.5 Times), And this one climbed out of power and Lock The clamping force ,Is a proportional relationship between the ,When climbing out of power more The more powerful the clamping force ,But the opposite also need a strong structure to support ,The climb out of the clamping force is smaller The smaller force ,Relative Lock Feeling less obvious ,So first consider the point to be re-designed Non- Latch Design Concept A B The design value ,For the design of the clamping force size ,There are decisive for its relations with the decay rate , A The larger the greater the clamping force BThe smaller the greater the clamping force ,When the clamping force greater the greater the attenuation rate When the cam actuator,Mother due to the angle of the cam,Produce a force to climb out Non-Latch Design Concept Cam structure because of its structural characteristics ,It is currently only used in washer Str