MVD技术变送器及故障诊断课件.pptVIP

* 12/13/96 19 RFT9739, Version 3 - Introduction (= Transparency 90) This graphic illustration of the LED indications can be found in the Job Aid section of the coursebook. It may come in handy for reference as the class proceeds with the following exercise. * * 12/13/96 26 Introduction and Theory, Part II (= Transparency 41) TXs 41-43 are illustrations of different junction boxes and wiring tables. Select the one for the sensor you demonstrated earlier. MMI-supplied cable is color-coded. When making terminal connections, match colors at each terminal. J-box terminals are labeled or numbered to facilitate correct connections. Make sure connections are secure and that bare wire is not exposed. * 12/13/96 28 Introduction and Theory, Part II (= Transparency 43) MMI-supplied cable is color-coded. When making terminal connections, match colors at each terminal. J-box terminals are labeled or numbered to facilitate correct connections. Make sure connections are secure and that bare wire is not exposed. * What is the effect across flow rates? Remember what we just said in the last slide, the higher the flow rate the lower the contribution of error as a result of the meter zero. The table on this slide illustrates this: at the highest flow rate the error is very small. This can also be illustrated by the graph at the right which shows the error curve of the meter when only the contribution of zero is shown. To illustrate the point the error was increased by a factor of 4x. RS-485 端 至变送器 电源接线端 状态 LED 核心处理器故障诊断 核心处理器故障诊断 诊断状态灯LED 闪烁状态在 每秒钟1次 – 正常 (25% 亮 / 75% 暗) 每秒钟1次 – 团状流 (25% 暗 / 75% 亮) 3 次快闪 – 传感器没被识别. 4 次快闪 – 故障 不亮 – 变送器没供电给核心处理器 - CP故障 A26 – MVD/核心处理器通讯问题 测量核心处理器端子阻值 ‘A’ to ‘B’ – 阻值 40 ~ 50KW ‘A’ to ‘2’, ‘B’ to ‘2’ - 阻值 20 ~25KW 阻值超过上述值，CP可能损坏。 核心处理器故障诊断 传感器检测线圈振幅 传感器型号 CMF (except 400IS) CMF 400IS D, DL DT F – Series R025, R050 R100 R200 T-Series F300 振幅值与测量管振动频率比值 3.4 mV/Hz 管子振动频率 2.7 mV/Hz 管子振动频率 3.4 mV/Hz 管子振动频率 3.4 mV/Hz 管子振动频率 3.4 mV/Hz 管子振动频率 2.