高速公路施工图设计说明解读.doc

摘要 本工程为某地区高速公路一段设计，该工程的实施将对带动该地区经济发展、方便地方人民群众生活起到积极作用；也是联系本地与外界的一条重要通道。 本次设计的路段是陕西延安至吴起高速公路A2段，全线采用双向四车道高速公路标准，全程5.5公里，设计速度为100公里/小时，路基宽度为26.0米。 依据老师所给的资料，通过对k0+000—k5+500路段的原始数据的分析，根据该路段的地质情况、地形、地物及水文等自然条件的特点，依据交通部颁发的公路工程标准、设计与施工技术规范，并运用纬地道路设计软件、AutoCAD对公路的路线平面线形、纵段面线形与横断面、路基路面进行了设计与计算，绘制出路线平面图、纵段面图、横断面图、直线曲线转角表、纵坡竖曲线表、标准横断面图、路基设计表、路面结构设计图、土石方数量表以及相关的其他图表，并且编写各部分相应的设计说明书等。通过这次设计不但了解建设公路的各个步骤, 而且也能熟练的运用AUTOCA进行制图.Abstract This works for a while in an area highway design, implementation of the project will promote economic development in the region , to facilitate local peoples lives play an active role ; is also an important channel to contact the local and the outside world. This section is designed toWu Qi highway A2 segment Yanan , Shaanxi , across the board with a two-way four-lane expressway standard , the entire 5.5 km , the design speed of 100 km / h , roadbed width of 26.0 meters . Based on the information given by the teacher , through the k0 +000- k5 +500 sections of the original analysis of the data , according to the characteristics of the geological conditions of the road , terrain , terrain and other natural hydrological conditions , issued by the Ministry of Transportation highway engineering standards design and construction specifications , and the use of latitude to road design software , AutoCAD horizontal alignment of the road route , longitudinal section and cross-sectional surface alignment , road embankment is designed and calculated to draw out the route plan , longitudinal section view of the Hengduan surface chart , line graph corner table , longitudinal vertical curve table , the standard cross-sectional view of roadbed design tables, pavement design , earthwork number of tables and other graphics -related , and each part of the preparation of the corresponding design manual. Through this design not only understand the various steps of the construction of the road , but also be able to skillfully use AUTOCAD drawing . Keywords : E