工程洒水车机械CAD图纸设计（五吨载重量）变速器改造设计和校核（新）.doc

工程洒水车设计（五吨载重量）变速器改造设计和校核 摘 要 伴随着现代物流的加快，专用车已成为我国汽车发展的一个重要方向，国家每年对城市专用车的需求量正在加大，市场对专用车产品技术含量和附加值的要求越来越高，Design and CHECK OF TRANSMISSION OF ENGINEERING sprinkler (5 tons deadweight) ABSTRACT Along with the acceleration of modern logistics, special cars have become an important direction of the vehicle development. Every year, the demand of city-special cars is growing, markets products dedicated to the technological content and added value of the increasingly high demand, and as a city and highway maintenance sprinkler special operations vehicles, its functional and performance requirements have become more sophisticated. This design is the five tons projects street sprinkler design (reequipment). And the key introduction and research analysis is general arrangement and the transmission gearbox reequipment design. The design for sprinkler can mainly increase torque by increasing the transmission ratio of the first and the second stall of original transmission on the basic of the chassis. Then take-power transmission devices from the intermediate shaft normally engage gears, through the drive shaft drive pump working work. Through the installation of pumps to the chassis frame assembly on the tank and piping assembly, operating under different working conditions for spraying operations. Design of transmission ratio of the first and second stallof transmission depends on the quantity of spraying water. The first stall transmission ratio change is mainly adapted to the sprinkler volume of operating conditions, as a stall transmission ratio, slow speed, volume in tanks and sprinkler width of the same circumstances; a short distance from the sprinkler, sprinkler volume is high. And the second stall transmission ratio change is mainly adapted to the less watering working status, because two stalls drive more than a relatively small, rapid speed, volume in tanks and sprinkler width of the same circumstances, a long distance from the sprinkler, sprinkler volume correspondi