10621中英文朗29495.docVIP

二、焊接中检验 Second, in the welding test （一）焊接工艺，（二）焊接缺陷，（三）焊接设备。 (a) welding process, (2) the welding defects, (3) the welding equipment. 三、焊后检验 Third, after welding inspection （一）外观检验 (a) visual inspection 1．利用低倍放大镜或肉眼观察焊缝表面是否有咬边、夹渣、气孔、裂纹等表面缺陷。 1. The use of low power magnifying glass or whether there is a macroscopic observation of weld surface bite edge, slag inclusion, porosity, surface defects such as cracks. 2．用焊接检验尺测量焊缝余高、焊瘤、凹陷、错口等。 2. Use welding inspection ruler, measure the weld residual high, flash, sag hi-lo, etc. 3．检验焊件是否变形。 3. Check whether welding deformation. （二）致密性试验 (2) th