SOP-Crytal Extraction.pptVIP

Purpose: To describe the COB Extraction Process from Crystal. 目的：描述COB拆壳流程 This Process consists of 2 sub-process. 此流程包括2个步骤 Stage 1: Tail Cutting Process 步骤1：剪外壳尾部 Stage 2: Cob Extraction Process. 步骤2：取出COB Standard Operating Procedure 标准作业程序 Title 主题: COB Extraction Process COB拆壳流程 Written by 制定人: Ray Molloy. Date 日期02/11/2011 Document Rev 文件版本 1.0 Page 1 of 8 共8页 ，第1页 Use the Snips provided, cut the tail from the Crystal as shown in photograph 用铁剪把USB外壳尾部剪掉，如图所示。 Standard Operating Procedure. 标准作业程序 Title 主题: COB Extraction Process COB拆壳流程 Written by 制定人: Ray Molloy. Date 日期02/11/2011 Document Rev 文件版本 1.0 Page 2 of 8 共8页，第2页 Stage 1: Tail Cutting Process 步骤1：剪外壳尾部 Standard Operating Procedure 标准作业程序 Title 主题: COB Extraction Process COB拆壳流程 Written by 制定人: Ray Molloy. Date 日期02/11/2011 Document Rev 文件版本 1.0 Page 3 of 8 共8页，第3页 When the tail is cut, the units are placed on a 100 unit tray (as shown in photo). 当USB外壳尾部被剪掉后，把它放回原来的吸塑盘。（见图片） Trays are place into a box with the following information For Example : Note: remark will state: “Tail Cut” 已经剪好尾部的产品装入纸箱中，在外箱标示数量，语言，产品编码，数量，备注。 1. Pre-production Check. 生产前的检查 DO NOT ADJUST THE TOOL. Always Ensure 6 slots are visible. 切勿调整治具。使用前检查露出来的槽是否是6条槽。 Slot # 1. 槽1 Slot # 6. 槽6 Stage 2 - Cob Extraction Process. 步骤2：取出COB Standard Operating Procedure 标准作业程序 Title 主题: COB Extraction Process COB拆壳流程 Written by 制定人: Ray Molloy. Date 日期02/11/2011 Document Rev 文件版本 1.0 Page 4 of 8 共8页，第4页 Insert the Crystal into the slot as shown in photograph. 如图所示，把USB放入槽内。 Make sure Crystal is pushed fully down into the fixture (as shown by Red and Green Arrow in photo). 确保USB已经压到位（如图绿色和红色箭头所示） Standard Operating Procedure 标准作业程序 Title 主题: COB Extraction Process COB拆壳流程 Written by 制定人: Ray Molloy. Date 日期02/11/2011 D