应发大纲.docVIP

Emergency Diesel Engine Generator Before and after the load test, the insulation measurement to be carried out for all electrical equipment that this test concerns such as alternators, Emergency switchboard, heaters and power transformers,负载试验前后应测量相关设备的绝缘，如发电机、应急配电板、加热器和变压器。 1.1. Alarm function 报警功能 Check and adjust the set value of pressure switches for alarm of lub. oil low pressure by manually operated hydraulic pump. Check and adjust the set value of temperature switches for alarm of cooling water high temperature and lub.oil high temperature by means of heating. Check the indication function of alarm on control box at the engine while set the value of alarm. And check the proper function of general alarm of emergency generator in monitoring system of ECR. 用手摇液压泵校对并调定滑油低压报警压力开关的调定值。用加热法校对并调定冷却水高温及滑油温度高报警温度开关调整值。整定报警值同时，检查机旁控制箱上报警显示功能，并检查集控室内监控系统的应急发电机总故障报警功能. 1.2. Safety protection 安全保护功能 Make diesel generator over speed by artificial actuation. Check the function of over speed and alarm for the stop by over speed. Over speed test carried out under no load condition. 人为造成柴油机超速，检查超速功能，同时检查超速停车报警功能。超速试验在没有负荷的状态下进行。 Safety alarm test for emergency generator 应急发电机安全报警试验 Test Setting Point Test result Remark Lub. Oil inlet pressure low alarm 0.8±0.2bar Lub. Oil outlet temp. high alarm 116°C±3 Cooling water outlet temp. high alarm 96°C±3 Over speed 2050r/min Simulation Common alarm (To AMS) -- Alarm No.20 Batter failure(To AMS) -- Alarm No.23 Fule oil leakage alarm -- LAL of cooling water -- E/G abnormal trip -- Alarm No.37 Over current -- Insulation resistance test绝缘测试 Insulation resistance test in cold condition (MΩ) and hot condition(MΩ) Item Cold condition Hot condition Stator winding Generator space heater starting of emergency generator. 应急发电机的启动试验 Start emergency generator in cold condition. Check that it is stable and reliable 冷态启动应急发电机，检查启动是否平稳可靠 Start test and start fail alarm test with the