高压计量箱要求.docVIP

11 KV Metering Unit(Ground Mounted) 11KV计量装置（地面安装） Specification Type Description ESCOM’s Requirements System and Environmental Parameters 系统和环境参数 Rated system frequency r.m.s phase-phase voltage 系统在额定频率下r.m.s相相电压 11kV±6% System frequency 系统频率 50Hz±2.5% Ambient temperature range 环境温度 -5 to + 45℃ Altitude: metres above sea level 海拔 1800 Relative humidity 相对湿度 95% Insulation Medium 绝缘介质 Primary insulation medium for CTs and VTs 电流电压互感器的主绝缘介质 Oil-SABS 555 Configuration Detail 配置细节 Configuration 配置 3 Ph 4 wires 3相4线 VT primary star point earthing 电压互感器主点接地 Yes-internal 是的-内置 VT secondary star point earthing 电压互感器次点接地 Yes-internal 是的-内置 Current Transformers 电流互感器 Accuracy精度 Class 0.5 Burden 负荷 15VA Secondary current 二次电流 5A Short time current withstand level-1 sec 短时间耐受电流-1秒 4kA CT ratio 电流互感器变比 Voltage Transformers 电压互感器 Accuracy精度 Class 0.5 Burden负荷 0 VA Primary nominal voltage 一次侧额定电压 kV 一次侧 11KV 0.5A Secondary nominal voltage 二次侧额定电压 110V 二次侧 110V 5A Insulation levels: 绝缘标准 Lightning impulse peak withstand耐雷水平 Rated short duration power-frequency r.m.s withstand voltage-60 sec 额定短时工频耐受电压-60秒 95kV 28kV Rated voltage factor额定电压因数 : continuous连续 30 seconds 30秒 1.2 * Un 1.9* Un Housing and Corrosion Protection 壳体和防腐蚀保护 Inland- mild steel内陆-软钢 (碳钢) Colour-Grey颜色：灰色 Class 2 Cable termination and enclosure 电缆终端和外壳 Bushing specification 套管规格 BS7215 Bushing type套管型号 Type C 630A with M16*2 thread size C型 630A 螺纹尺寸：M16*2 Creepage漏电 Per BS7215 按照BS7215标准 Removable gland plate 可移动密封板 Yes Boss to be provided for cable earthing 备有电缆接地接点 Yes Incoming cable requirements进线要求 3* single core/1* three core 3*单芯/1*三芯 1* three core 1*三芯 Cable material 电缆材料 Copper铜 Size of cross section截面积 Up to 120 mm2 高达120 mm2 Type of cable 电缆类型 PILC/XLPE Compression gland required 要求提供压缩密封套 Yes Minimum distance from gland plate to centre line of bushing 盖板到套管中心线的最小距离 600mm General Requirements 一般要求