设计指南-晒纹篇.docVIP

Design Guidelines-Choosing a surface finish/设计指南-晒纹篇 2007-4-28 17:22:41 When designing a part for injection molding, it is important to keep in mind the relationships between surface finish, moldability, cost and lead time. 当设计一个组成部分注塑,这是很重要的,记住这一关系表面处理,moldability、成本和交货时间。Figure 1 contains the list of standard surface finishes available through Protomolds rapid injection molding service, listed in order from lowest to highest cost. 图1包含串标准化的表面镀层可通过Protomold的快速成型服务依次从低到高的成本。 Figure 1: List of available standard finishes Higher Cost PM-F0: Non-cosmetic—finish to Protomold discretion PM-F1 Low-cosmetic—most toolmarks removed SPI-C1: 600 grit stone, 10-12 Ra SPI-B1: 600 grit paper, 2-3 Ra PM-T1: Protomold texture, SPI-C1 followed by light bead blast PM-T2: Protomold texture, SPI-C1 followed by medium bead blast SPI-A2: Grade #2 Diamond Buff, 1-2 Ra PM in the table signifies a surface finish adjusted to fit the rapid injection molding process, where SPI The Society of the Plastics Industry denotes an industry-standard finish. “点”象征着桌子表面光洁度调整以适应快速注射成型工艺,在那里SPI 塑料工业的社会 表示有灵活的完成。 The photographs shown in Figure 2 illustrate the difference in cosmetic appearance for a few of these options on some example parts. 如图2所拍的照片,外观上的差异,说明了几个这样的选择在一些例子说明部分。Figure 2: Surface finish examplesIf the part will not be visible to the end user, you will probably choose to specify either PM-F0 or PM-F1 using the drop-down menus on your ProtoQuote see sample . But many times your design will require a more cosmetic surface finish. In these cases there are two key things to keep in mind: 若部分将是不可见的终端用户,你可能选择指定PM-F0或PM-F1也在你使用下拉菜单ProtoQuote 参考范例 。但是许多次以后你的设计需要一个更加化妆品表面光洁度。在这些情况下有两个关键因素要牢记:Polishing: Smoother part surfaces are achieved using manual mold polishing techniques. Consider a part with tall, thin and curved ribs which need to have an SPI-A2 finish. In this case you should expect a significant cost increase because it is very time consuming to polish deep, narrow slots in mo