II-QC-2008 喷粉车间检验指导书 Painting workshop inspection instruction(1.docVIP

鞍兆（中山）电器有限公司 Onshiu (Zhongshan）Electrical Appliance Co., Ltd. 编号/File No：II/QC-2008 版本版次/Version： B/2 喷粉车间检验指导书 Painting workshop inspection instruction 页次/Page: 1/4 实施/Valid Date: 2014-11-20 编制/Editor: Zhihong Liu 审核/Reviewer: He haiyan 批准Approval: Xuehua Liu 1.0 目的Purpose 为使质检员按规定要求进行检验,控制产品质量. It is for QC to inspect according to the requirements and control the products quality. 2.0 范围Scope 适用于喷粉车间质检员对本车间生产的产品进行检验. It is applied for shopfloor QC to inspect the products 3.0 名词定义Term Definition 无 None 4.0 权责Authority and Responsibility 无 None 5.0 工作程序Working procedure 5.1 质检员按下表要求对电泳和喷粉产品进行检验，第1-3项同时适用于电泳和喷粉产品，第4-10项仅适用于喷粉产品。所有测试取样必须随线取工件检查。而且必须全产品均匀测试，单件检查点不少于3点。 The inspectors shall inspect the electrophoresis and painting products according to the requirements as follow, No.1-3 meanwhile for electrophoresis and painting products, No.4-10 only for painting products. All test sample must from this line and use product, and test points with this part must from different areas , at least 3 points. 序号Nr. 项目Item 检 验 内 容 Inspection requirements 检测方法Method 频次Frequency 备注Remarks 1 外观 Appearance 参见 see in II/QC-0004 见5.2 see in 5.2 壳体内不得有水及电泳漆 The battery inside must free from water and electrophoresis paint 2 颜色 Color 参见see in II/QC-1125 封样参见sample see in II/QC-0001 1次/天 Once/day 3 厚度 Thickness 参见see in II/QC-1125 1次/天 Once/day 4 附着力 Adhesion 根据壳体型号测试时的位置：1.HM4.HM3.HRR..TRT.TRN.TRGK壳体：从工件两侧各取5个测试点（见图1）。 划格宽度：散热片有多宽划多宽; 划格长:25-30mm 2.HOR、VENTO壳体：在壳体的底部（见图2）取2个测试点; 1号测试点划格面为20×30mm；2号测试点划格面为15×20mm the test position is according to the battery type: For the HM4.HM3.HRR.TRT.TRN.TRGK battery: from the side position of the part and take 5 test points (refer to picture 1). The grid width: the fin width; the grid length: 25-30mm HOR,VENTO battery: at the bottom of battery (refer to picture2) , take 2 test points , one point the grid is 20×30mm, the other one grid is 15×2