Plating Training Internal jaa 5-23.pptVIP

* The numerical rating system is based on the area of the substrate that exhibits corrosion, by the following formula: 数值评级系统是建立在底材生锈面积计算，计算公式如下： Rp =3(2-IogA) where A is the percentage of the total area which shows basis metal corrosion Rp or deteration of the coating Ra , is rounded off to the nearest whole number, leading to the tabulation given in Table 1 Corrosion Specification 59991 Rp = 3（2 - IogA），其中A为底材的生锈总面积Rp的百分率或者是镀层生锈总面积Ra的百分率,是四舍五入至最接近的整数，如表1所示. Corrosion Specification 59991 Dot charts and color photographs for coatings are presented in the ISO 10289-standard. These charts and photographs represent the maximum amount of corrosion permissible for a given rating; there is a chart or photograph (in 1:1 scale) for each rating from 1 to 9. done separate for parts with white and/or red corrosion. 白色锈点图表和红色锈迹的彩色图都可在ISO10289找到.这些图表和照片都是以1:1比例,显示了从1到9不同等级可接受腐蚀程度(白锈和红锈). A specimen worse than the chart or photograph for rating 1 is assigned a rating of O unless a fractional rating is assigned between 1 and O. 样品差于图表或 彩色图片的等级1,除非一个分数等级介于1和0 之间,一般情况下都判定为0. ISO 10289 Dot Charts for Nickel Plating ISO 10289 Dot charts for Zinc Plating Surface Class/Cosmetic Requirements Spec 50022 rev 2 3.2 Inspection conditions: 检查条件 3.2.1 Lightning the parts to be inspected shall be viewed within 100 to 125 foot -candles of illumination at the part 3.2.1 光源 产品置于100~125呎烛光的光源下观察。 3.2.2 Viewing . Part shall be inspected at a distance of 24” and in the position as it would be in the finished assembled product. In addition the viewing angle shall be 30 degrees of horizontal. In the other words as the end used will see the product. The defect should be detected within 5 seconds. 3.2.2 检验.产品检验距离应为24 英寸,产品的摆放位置应符合最终产品装配位置。此外检验的视角要与产品成30度角。换言之，就是最终用户看到该产品的方向和距离。缺陷应该能在5秒内被看到。 * Examples Zebra Confidential * Zinc Plating Failures Zebra Confidential * Nickel Plating Failures Zebra Confidential * Powdered Metal Zebra Confidential * Exemptions Zebra Confidential * Fastene