在设备分解时机械密封故障的维修8.pptxVIP

Troubleshooting mechanical seals at equipment disassembly 在设备分解时机械密封故障的维修8 Steven_Tianjin THE HARD FACE硬面 Non Concentric pattern. The wear track is not in the center of the hard face. 不同心的图案,磨损轨迹不在硬面的中心 The shaft is bending because the pump is running off of its best efficiency point. 因为泵运行在它的最佳效率点以外,轴弯曲 Poor bearing fit. /坏的轴承配合 Pipe strain. /管线应力 Temperature growth is distorting the stuffing box. /温度增长扭曲填料箱 The stationary face is not centered to the shaft./静面与轴不同心 Misalignment between the pump and its driver./泵和它的驱动之间的没对准 THE HARD FACE硬面 Uneven face wear. The hard face is distorted: 不平的磨损面,硬面被扭曲 High pressure. 高压 Excessive temperature. 过高的温度 Over tightening of the stationary face against the stuffing box. 静面到填料箱过紧 THE HARD FACE硬面 The clamping forces are not equal and opposite. 钳位力不平衡和对立 The hard face is not wide enough. 硬面不够宽 You are using a two bolt gland and the gland is too thin causing it to distort. 你使用一个两螺栓压盖,并且压盖太薄引起它的扭曲 You are using a pump seal in a motion seal application. 在一个移动密封应用中你使用一个泵的密封 THE HARD FACE硬面 The product is sticking to the seal face. The product is changing state and becoming a solid. Most products solidify for the following reasons: 产品粘到密封面上.产品转换状态并且变成一个固体.大多数产品因为以下原因固化 A change in temperature. 温度的变化 A change in pressure. 压力的变化 Dilatants will solidify with agitation. As an example: cream becomes butter. 膨胀物将与搅拌固化.作为一个例子,奶油变为黄油 Some products solidify when two or more chemicals are mixed together. 当两个或更多的化学物质混合在一起的时候,一些产品固化 THE HARD FACE硬面 The hard face is not flat. 硬面不平 Mishandling. 违反运行规程 Poor packaging. 不好的包装 The hard face has been installed backwards and you are running on a non lapped surface. ??硬面被安装的向后,并且你运行在一个不是研磨的面上 It was shipped out of flat. 它被运输出时不平