日光灯世置电源使用说明.docVIP

The instruction for use of flourescent tube 日光灯产品使用说明书 Before use, please read the products’ instruction carefully. We won’t inform clients previously while change the content. 使用前，请完整阅读安装说明,内容变更不预先通知。 一： Disassemble and check up: open the package, check the products carefully; Fetch and lay lightly; if any damage, please reserve package and tell us soon; please don’t try to use the damaged products. 拆封检查：打开包装，仔细检查产品;小心轻取轻放；如发任何损坏，请保留包装并及时向我公司反映；请不要尝试使用已损坏的产品。 二：Items of attention: Before installation, please read the mark content on fluorescent tube; avoid strenuous vibration; this type tube haven’t function of waterproof, so shall install waterproof holder while outdoor use; Check the voltage and current whether meet requirement; Please don’t dissemble the tube casually without our authorization; Please don’t lay the unused tubes into the wet environment. Installation plan: need to make a complete scheme before installation, which will reduce the unnecessary difficults and short the time of installation. 注意事项： 安装前请阅读灯管标贴内容；避免灯管剧烈震动；该灯管无防水效果，户外使用请使用防水支架；检查电压、电流是否符合要求；未经授权，请不要拆解LED日光灯灯管；如暂不使用的灯管不可放置于潮湿环境中保存。安装规划：安装需要事先作出一个规划，这样会减少在安装过程中遇到不必要的困难和缩短安装时间。 三：Installation steps/安装步骤： 1：Please ensure disconnection of switch and ensure no voltage. 安装前请确保开关断开及使用电压 2：Starter and ballast are unnecessary to LED tubes, so please ensure their disconnection or abandon. LED日光灯不需要启辉器及镇流器，请确保上述部件处于断开状态，或直接去掉。 3：接线方式：AC输入线与外置电源输入端连接，支架灯座分别连接外置电源输出端 “DC+V”/“DC-V” 并统一接法便于灯管安装。（即与支架两端连接）。 Connection Instruction: AC input line and the power adapter input are connected, bracket lamp holder are connected to the power adapter output DC + V / DC-V and unified connection easily for lamp installation. That is connected with the bracket at both ends. 。 Be certain of right connection, fold switch, then tube will light. 确认连接正确，打开开关，灯管亮起。 接线图： Connection Instruction photo: Diagram of simple installation：产品简易安装示意图：