遥控电位器使用说明书-almsun.docVIP

Remote control potentiometer operating instructions 一，Interface specification Annotation：Figure 1 indicate the function of each interface.In figure 2, there are 2 set of special function of welding plate.The T2 is used as a keypress function .The function of the T1 will be decribed in the pinstructions using process as below . Attention：1， Dont reverse the interface of display panel control and the interface of audio source selection control .Dont reversethe the input and output interface of audio . 2，The power input is dc 12 v 0.5 A regulated power supply.Pay attention to is the Plus-n-Minus . Instructions After connected each line the power according to the above diagram,power on. 1，The remote control of volume ：Press the VOL + or bring about a button▲ on the remote control can increase the volume，Press VOL - or ▼ to can reduce the volume，At the same time you also can also manually rotating potentiometer to realize manual control current volume.。When change volume , the corresponding parameter volume values on the LED display board will becomes large and small.The numerical range of 01-99.(Due to the cause of the error, some minimum volume display value is 00) 2，Audio input channel selection：Press the ?or ?button on the remote control switch the current audio input channel.At the same time you can also through presses the button one time change an input channel.the corresponding input channel number on LED display panel will change too，There total four groups of audio input, respectively shows A, b, C, d four letters. 3，Mute function：Press mute button on the remote control to get into silent modePress it again to exit the silent mode.Silent mode LED display as below（This function only fixed two and three effective person） 4，The function of the power supply switch on and off：Press the power switch of the red button on the remote control to open and shut off the power.The corresponding total power relay in the closed state whe