从技术角度看都灵压缩机.pptVIP

* * Officine Mario Dorin S.p.A. Semi-hermetic Compressors: Some technical solution Officine Mario Dorin S.p.A. Compressors with splash-lubrication (without forced oil-pump) Semi-hermetic Compressors: Some technical solution Officine Mario Dorin S.p.A. Officine Mario Dorin S.p.A. H1-H2-H32-H34-H4 ranges 3. HFC semihermetic compressors – H range DORIN DESIGN COMPETITION design lower pressure drops in oil circuit lower thermal load for the lubricant better lubrication longer compressor life DORIN DESIGN: Officine Mario Dorin S.p.A. Reduced noise levels 3. New H Range – State-of-the-art Thanks to the new valve plates, to the new internal passages design, and to the new bearings also the H compressors are showing very low Noise levels compared with the K models. (But compared with the other compressor brands in the market also!) Comparison tests had showed noise levels reduction up to 13 db(A). Officine Mario Dorin S.p.A. Improved Performances 3. New H Range – State-of-the-art Some comparison tests between the new H1000CS and an equivalent Bitzer model (Octagon range) showed the following results: Mass flow = +17% with the same displ.(@ -35°C evap.temp. R404A) Effective Mass Flow of a H1000CS (48,8 m3/h) +3% of an equivalent Bitzer model with a displacement of 56 m3/h. Gas pulsations on the discharge line reduce by 50% Officine Mario Dorin S.p.A. Officine Mario Dorin S.p.A. All compressors models can be used for INVERTER applications Standard compressors can work: between 25Hz and 65Hz for models not equipped with oil pump between 30Hz and 65Hz for models equipped with oil pump 4. HFC semihermetic compressors – H range Use of specific electric motors Officine Mario Dorin S.p.A. Officine Mario Dorin S.p.A. DORIN Design: Main Bearing : Diam. 28 mm. Specific loads on the bearings: -22% One of most common equivalent Compr. Main bearing: diam. 25 mm Shaft Comparison Officine Mario Dorin S.p.A. Officine Mario Dorin S.p.A.