Milling scupper.docVIP

Milling scupper To have good water tightness, aluminum alloy doors and Windows must drain on the Windows and doors, make the water inside the doors and Windows can row to the outdoor, in order to keep the rain in the cavity would be able to discharge, must drain, drain specifications for 5 mm x 30 mm In the doors and Windows inside and outside of hole machining, pay special attention to the following: Attention should be paid to try to open open inside and outside holes within profile cavity bottom water, prevent profiles such as internal water. The number and distribution of the drain A, casement Windows border length 900 mm or less, the sink, open two position is 120 mm from both ends. B, fixed window does not open flume. 6.12.6.3 milling hardware installation groove In specific processing, can change according to the size of the actuator tool and feed, implementation processing of slots. Actuator in, for example, a hand hole machining, must pay attention to the middle hole are used for milling cutter diameter phi 12, and aperture for phi 10, both sides cant cutting tool interoperability. After milling, aperture position correctly, smooth, no burr, the installation of the actuator. 6.12.6.4 profile set Angle of stitching 1, group Angle splicing is one of the key working procedure during the manufacture of the aluminum alloy doors and Windows, set of Angle quality directly affects the performance into a window. Set is Angle must assure component visible surface and components are orthogonal, allowable deviation + 0.5, the box fan group Angle should meet the size requirements, after first article must be checked in mass production, the rest of the spot check, small batch and the unit production, to check. The difference between the doors and Windows of the diagonal dimension of sash should not be greater than 2.0 mm. In the concrete, visual reality. After 2, group Angle, the same profile adjacent components group Angle flatness 0.5 mm or less the same; Di