aix4下确认cpu频率.doc

/support/docview.wss?rs=0q=CPUuid=isg1hintsTips0198loc=en_UScs=utf-8lang= This document applies to AIX Versions 4 and 5. While there is not a direct command to determine processor speed in AIX V4, the best place to start is with the uname command. Executing uname -m produces output of the following form: xxyyyyyymmss The meanings of the placeholders are as follows: xx = 00 yyyyyy = Unique CPU ID mm = Model ID - these are the numbers to use to determine CPU speed ss = 00 (Submodel) By cross-referencing the values from the uname -m output with the table below, you can easily determine the processor speed. To determine cpu speed with AIX V5, use the following command: lsattr -El proc0 The frequency line returns the speed of the cpu. Note on some machines the value represented by the frequency line will have to be rounded to the nearest integer. For example, the frequency reported on a 7025-F80 is 451200000, which is then rounded to 450MHz. Model ID Machine Type Processor Speed Architecture 02 7015-930 25 Power 10 7013-530 25 Power 10 7016-730 25 Power 11 7013-540 30 Power 14 7013-540 30 Power 18 7013-53H 33 Power 1C 7013-550 41.6 Power 20 7015-930 25 Power 2E 7015-950 41 Power 30 7013-520 20 Power 31 7012-320 20 Power 34 7013-52H 25 Power 35 7012-32H 25 Power 3