Control of inspection equipment.docVIP

Issued Date：1st Sep.2002 Control of Inspection Equipment Doc. No.：CC-H0-B102 Updated Date： Rev.：A0 Page(s)：4 Purpose To define procedure for effective management and maintenance of inspection equipment’s function and precision to assure product’s quality and equipment is reliable. Scope Applied for inspection equipment control of each department. Definition 3.1.Inspection equipment：refers to measurement equipment, meters or testing equipment for receiving inspection, in process inspection, final inspection and engineering maintenance etc. 3.2.Benchmark：to calibrate the normal measurement gauge and some of them need to be specified by National or International Standard. 3.3.Inspection gauge：gauge used for receiving inspection, in process inspection, final inspection etc. 3.4.Tools：used for measurement of project maintenance which have no direct effect on product’s quality. 3.5.Testing equipment：used for product function testing. Responsibility GM office is responsible for this procedure’s control. QA department is the direct responsible department for this procedure. Procedure： Buy-in of new devices：using department should provide purchasing requirement approved by supervisor to Purchasing department. Receiving：receiving personnel should check the calibration of devices. If not accepted, devices should be returned. 5.3 Category and numbering： 5.3.1Category Approved Checked Prepared (1)Benchmark devices：devices used for calibration or inspection. (2)Inspection gauge：devices used for in process and final inspection. (3)Tools：devices used in factory or building site. (4)Inspection devices：devices used for product’s function inspection. 5.3.2Numbering： × ×× － ×× Sequence of same kind of devices 1.Benchmark Equipment code（Appendix 1） 2.Inspection gauge Usage explanation（1、Standard ruler2、Inspection gauge3、Tools 4、Inspection devices） 3.Tools