BlueTooth21EDRSpec.docVIP

Spec： 1.1 Overview TOPOLOGY 1 Piconet：basic piconet physical channel adapted piconet physical channel supporting adaptive frequency hopping 2 Scatternet A Bluetooth device that is a member of two or more piconets is said to be involved in a scatternet 【Note】 1 A Bluetooth device may participate concurrently in two or more piconets. 2 A Bluetooth device can never be a master of more than one piconet. Logical transport types spec. P41 异步面向连接 ACL 控制 LMP ACL-C 用户 L2CAP ACL-U 活动物理链路，基础或适应型物理信道 可靠或受时间限制，双向，点对点。同步面向连接 SCO 流（非帧化）SCO-S 活动物理链路，基础或适应型物理信道 双向，对称，点对点，AV 信道。适用于 64Kb/s 恒速数据。 扩展同步面向连接 eSCO 流（非帧化）eSCO-S 活动物理链路，基础或适应型物理信道 双向，对称或不对称，点对点，通用规则数据，受限重新传输。适用于与主蓝牙设备时钟同步的恒速数据。 活动从设备广播 ASB 用户 L2CAP ASB-U 活动物理链路，基础或适应型物理信道 不可靠，单向广播到与物理信道同步的任意设备。适用于广播 L2CAP 组。 休眠从设备广播 PSB 控制 LMP PSB- C，用户 L2CAP PSB-U 休眠物理链路，基础或适应型物理信道 不可靠，单向广播至所有微微网设备。适用于至休眠设备的 LMP 和 L2CAP 通信量，及从休眠设备发出的访问请求。 Operational Mode：Active，Sniff，Hold，Park Operational State：Connected，Inquiry，Page BD_ADDR：48bit NAP 16bit UAP 8bit LAP 24bit AM_ADDR：Active Member Address，3bit，Broadcast――000 PM_ADDR：Parked Member Address，8bit AR_ADDR：Access Request Address Park Mode 1.2 USB TRANSPORT LAYER An HCI frame, consisting of an HCI header and HCI data, should be contained in one USB transaction. A USB transaction is defined as one or more USB frames that contain the data from one IO request. 1 CONTROL ENDPOINT Endpoint 0 will also be used to allow the host to send HCI-specific commands to the host controller. 2 BULK ENDPOINTS ACL data 用于传输 ACL 分组 3 INTERRUPT ENDPOINT ensure that events are delivered in a predictable and timely manner 4 ISOCHRONOUS ENDPOINTS synchronous data 用于传输 SCO 分组 HCI CORE SYSTEM ARCHITECTURE The HCI Host Controller Interface provides a command interface to the baseband controller and link manager, and access to configuration parameters. This interface provides a uniform method of accessing the Bluetooth baseband capabilities. 1.3.1 HCI FLOW CO