平面设计ps制作马赛克效果-经典创想.docVIP

　　利用PS软件制作低多边大色块马赛克背景图，背景图效果非常好看，此效果的背景图在制作过程也是很简单的，先我们来看看背景图的运用效果，再来制作! 　　打开PS软件，新建图层，设置宽高，我设置都是1000像素 设置前景色，我是随便设置色值的 设置背景色，同样也是随意设置的色值 　　 新建一个图层，选择滤镜→渲染→云彩，这样我得到一个对比度不是那么强烈的云彩　 接下来，我们进行滤镜→像素化→马赛克　　 这里单元格设置大小为60方块　 复制图层1后ctrl+t旋转90度，注意我给的数值!原因是：旋转90度是避免效果图出现左右对称　 　　完成后把图层1拷贝，图层混合模式选择叠加模式　 　ctrl+t自由变化图层1，设置的数值相反 　　 　　把边上不整齐的部分裁剪掉 　　 　　新建一个渐变调整层。色彩可以选自己喜欢的 　　 　　更改调整层的混合模式为颜色，到这里就完成背景图的制作了 　　 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into