北京市建设工程证取样和送检管理规定(试行).docVIP

北京市建设工程见证取样和送检管理规定（试行） 第一条 为规范建设工程见证取样和送检工作，保证建设工程质量，根据《建设工程质量管理条例》、《建设工程质量检测管理办法》等法律法规，结合本市实际，制定本规定。 第二条，适用本规定。 本规定所称见证取样和送检是指在建设单位或监理单位人员的见证下，由施工单位的人员对工程中涉及结构安全的试块、试件和材料，并送至进行检测。 见证取样和送检实施监督管理预应力钢绞线、锚夹具；（）沥青、沥青混合料；）应依法承担相应的责任施工监理服务收费基准价应依法承担相应的责任明示、暗示推荐或指定检测机构附件1： 见证取样和送检见证人告知书 质量监督站： 检 测 机 构： 我单位决定，由 同志担任 工程见证取样和送检见证人。有关的印章和签字如下，请查收备案。 见证取样和送检印章 见证人签字 建设单位项目部名称（盖章）： 项目负责人： 年 月 日 监理单位项目部名称（盖章） the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the