I类切口预防使抗菌药物管理规范2012.3.28.docVIP

临朐县人民医院Ⅰ类切口手术预防性抗菌药物使用规范 为规范Ⅰ类 清洁 切口手术围手术期预防性使用抗菌药物（下称预防用药）的管理，减少细菌耐药，降低医药费用，促进合理用药，依据《抗菌药物临床应用指导原则》（卫办医政发〔2004〕285号）和《抗菌药物临床应用管理办法》（卫生部令第84号）腹股沟疝修补术（包括补片修补术）、甲状腺疾病手术、乳腺疾病手术、关节镜检查手术、颈动脉内膜剥脱手术、颅骨肿物切除手术和经血管途径介入诊断手术患者原则上不预防使用抗菌药物 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. See Figure 18 The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force, and check the coupling flutter and before connecting the circle gradually changes its value should be less than 0.02mm. Tightening torque of the coupling bolts shall compl