弱视治疗仪的选标准——合适的才是最好的.docVIP

首先，关于弱视，我们要知道，只要早期发现，及时治疗，弱视是有希望治好的。 由于某种原因，患孩自幼视力很差，但眼睛外表看来与正常人一样，但无论戴什么眼镜视力总达不到0.9，这种眼病通常称为“弱视”。我国有3亿多儿童，估计有1000多万儿童患有弱视。这些儿童如果得不到及时的治疗，对国家的建设和个人的前途都是不可弥补的损失。家长如怀疑自己的孩子视力有异常，应及早请有经验的眼科医生检查和治疗。 弱视的治疗效果与年龄有密切关系。年龄越小，疗效越好，成人后则治疗基本无望了。 弱视有很多治疗方法，如遮盖法、后像法、闪烁红光法，视觉刺激仪法，氦-氖激光治疗法和同视机治疗法等。医生根据患孩的屈光不正程度配戴眼镜后，对不同类型弱视采用不同治疗方法。家长应配合医生，在医生的指导和观察下，治疗才能取得如期效果。 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force, and check the coupling flutter and befor