普印力行式打印纸张选择标准.docVIP

普印力行式打印机纸张选择标准 1. 目的 对普印力行式打印机纸张选择提供标准的规格指导。 理想情况下，任何，应首先通过普印力打印机其。 公司可以提供的设计及处理分析援助。2. 环境 本标准适用于普印力连续纸激光打印机和连续纸行式打印机。 本标准适用于以上所列打印机，操作环境要求如下： 温度 湿度 5oC 到 40oC 10% 到 90% (无冷凝) 3. 参考文献 ISO-2784: 信息处理连续打印纸 – 尺寸和齿孔标准 ANSI-X3.96: 连续商业打印纸张 (单层) – 纸张尺寸标准 定义/术语 齿孔碎屑: CHAFF: Residual bits of paper not fully removed after the punch process that creates Tractor Pinholes, Major/Minor perforations, etc. 切口点: CUT POINT: Area along a perforation where a cut that extends thru the entire form has been made. 切口连接比率: CUT-TO-TIE: Ratio of cut points to tie points occurring along a perforation. 平整度: EVENNESS: Amount of variation between the thickest and thinnest points measured across the print area (between the Side Perfs). 纸张厚度: FORM THICKNESS: Thickness as measured at the thickest point of the overall form. This includes glue lines, compressed staples, perforations, etc. This is not limited to the printed region of the form. 页边空白: MARGIN: Region outside the print area of the form. Typically boundaried by the outermost vertical perforations (where the tractor pinholes are located), and the edge of the form. 打印区域: PRINT AREA: Region where printing occurs, always between the side perfs. 打印部位: PRINT STATION: Area within the printer where actual impacts associated with printing takes place on the form. 钉紧孔: STAPLE: Punch-cut fastening stitch(es) located along the vertical edge and within the side perf region of a multipart form. 隆起: TENTING: Measured thickness difference between print area of the form and the peak thickness of a Major Perf. Typically caused by overly stiff perfs or mis-registration of inner parts of multi part forms. 连接点: TIE POINT: Area along a perforation between cut points. The following figures will assist in the definition of terms found throughout this document. 图1: 连续纸张基本术语 图2: 撕纸线向内和向外定义 Side View of form 图3: 撕纸线切口点和连接点定义 4. 指导标准 4.1 应用环境： 我们建议所有在之前。绝不允许环境损害如脱胶，皱褶，折叠等。4.2 纸张类型： 1. 穿孔折叠单层纸张 2. 2到6层无碳复写纸张 3. 2到4层无碳复写纸张 所有纸张宽度范围3 到