思想品德：第二《在承担责任中成长》教案(鲁教版九年级).docVIP

第二课 在承担责任中成长 教案 第一框《承担关爱集体的责任》 ●教学目标： 知识目标：通过本课的教学，使学生认识到集体和个人的关系；知道集体利益和个人利益是相互依存的；集体应充分尊重和保护个人利益,个人更应该关心和维护集体利益,关爱集体,人人有责。 能力目标：正确认识集体利益和个人利益关系的能力；具有关爱集体的实践能力，自觉地维护集体荣誉和利益的行为能力，发扬集体的好作风，善于团结他人的能力 觉悟目标：培养学生关爱集体和社会的责任感和道德情操；树立责任意识；体验团结就是力量的自豪感和快乐。 ●教学重点与难点： 1、重点：是使学生弄清集体利益和个人利益是相互依存的关系 2、难点：是如何关爱集体。 教学方法、手段： 多媒体课件，让学生自己举例，运用启发式教学方法，用具体、生动的事例以及美妙的歌曲感染、教育学生，引导学生正确认识承担关爱集体的责任。 ●教学过程： 第一课时　　第二课第一框　《承担关爱集体的责任》 ◆导入新课：播放多媒体课件中的歌曲《爱的奉献》，鼓励学生一起唱。[来源:Zxxk.Com][来源:学|科|网][来源:学。科。网Z。X。X。K][来源:学科网ZXXK][来源:Z,xx,k.Com] appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged. 7.5.8 cables neat and clean, solid binding, binding process in appeara