WifiModuleManual.docVIP

Wifi Module Manual Power supply: 6-16V Interface: VCC 5V power supply end (The voltage must be 5V, capable as output power) TXD connects to the RXD of MCU RXD connects to the TXD of MCU GND connects to the GND of MCU Default Baud Rate: 9600 wifi Account: TOLNK Code:Web Address: Video Address: :8080 (You can use the chrome or Firefox browser to access to the camera directly)HOW TO USE: 1, Charging the module, voltage range: 6.5V-16V. 2, When power supply is on, search the wifi network with a cell phone or laptop, and connect to TOLNK, code: 3, Receive video with computer software, run MJPG..exe and click connect button. If the light on the camera is not on, it means something wrong with the camera connection. You can use the wifi video only when the light on the camera is on.  Connect Wifi, account: TOLNK, code: Parameters Setting Open browser, and enter address: , log in，user: admin, password: admin. Modify System Settings: Wireless network: AP and Infra AP: use wifi module as the routers, so that cell phones and computers can be connected directly to the wifi module. Infra: use wifi module as basic equipment to connect to other routers. Two Applications: If you use wifi module as the router to connect your phone and computer, please pay attention to the following Settings: The wireless network must be AP. The wireless name can be arbitrary. The wireless network key is the code for your mobile phone or computer to connect to the wifi module. Suggest you not to make any changes to the wireless IP. No need to modify other options, save parameters, and restart the wifi module. If you want to connect the wifi module to other routers, so please pay attention to the following settings: Wireless network must be Infra Wireless network name must be the router’s name. (Any symbol can’t go wrong, capital and small letter neither) Wireless network code must be the router’s code. (Any symbol can’t go wrong, capital and smal