CCNA第三学期英文答案chapter6.docVIP

1 窗体顶端 Refer to the exhibit. Which three statements describe the network design shown in the exhibit? (Choose three.) This design will not scale easily. The router merges the VLANs into a single broadcast domain. This design uses more switch and router ports than are necessary. This design exceeds the maximum number of VLANs that can be attached to a switch. This design requires the use of the ISL or 802.1q protocol on the links between the switch and the router. If the physical interfaces between the switch and router are operational, the devices on the different VLANs can communicate through the router. 窗体底端 2 窗体顶端 A router has two FastEthernet interfaces and needs to connect to four VLANs in the local network. How can this be accomplished using the fewest number of physical interfaces without unnecessarily decreasing network performance? Implement a router-on-a-stick configuration. Add a second router to handle the inter-VLAN traffic. Use a hub to connect the four VLANS with a FastEthernet interface on the router. Interconnect the VLANs via the two additional FastEthernet interfaces. 窗体底端 3 窗体顶端 Refer to the exhibit. All devices are configured as shown in the exhibit. PC2 can successfully ping the F0/0 interface on R1. PC2 cannot ping PC1. What might be the reason for this failure? R1 interface F0/1 has not been configured for subinterface operation. S1 interface F0/6 needs to be configured for operation in VLAN10. S1 interface F0/8 is in the wrong VLAN. S1 port F0/6 is not in VLAN10. 窗体底端 4 窗体顶端 Refer to the exhibit. The commands for a router to connect to a trunked uplink are shown in the exhibit. A packet is received from IP address 192.168.1.54. The packet destination address is 192.168.1.120. What will the router do with this packet? The router will forward the packet out interface FastEthernet 0/1.1 tagged for VLAN 10. The router will forward the packet out interface FastEther