M272发动机.pptVIP

Actuation of the power steering pump pressure regulator valve 通过由执行图来触动助力泵上的压力调节阀来优化发动机的损耗,从而减小发动机的 载荷. The engine load is reduced for the consumption optimization by the performance map-dependent actuation of the pressure regulator valve on the power steering pump. 根据当前的驾驶条件,按方向助力的要求调整阀的开度.根据下列输入信号: *发动机转速;*车速(通过CAN);*方向转角(通过CAN);*打方向的速度(通过CAN). 压力调节阀与助力泵连接在一起.它根据执行图可以在10%~90%之间被触发,流量 被控制在2~9l/min.在室温时,线圈电阻大约为5.5,电流消耗大约为1.9~2.5A.点火 开关打开并起动时,压力调节阀完全打开. The valve port is adjusted corresponding to the steering assistance required by the current driving condition and is dependent on the following input signals: *Engine rpm *Vehicle speed (over CAN) *Steering angle (over CAN) *Steering angle speed (over CAN). The pressure regulator valve is permanently connected with the power steering pump. It is actuated performance map-dependent with a duty cycle of 10 to 90 % and controls the delivery volume of the power steering pump between 2 to 9 l/min. The coil resistance at room temperature is approx. 5.5 and the power consumption is approx. 1.9 - 2.5 A. With ignition ON and during the engine start, the pressure regulator valve is completely open. ECO valve ECO阀是助力泵的一个部件,与泵连接在一起.在一些操作条件下,通过阀来调节助力泵的载荷,从而优 化发动机的损耗.泵的流量在2~9l/min之间变化,通过存储在ECU里的执行图来调整.用PWM信号触发. 工作循环:10%~90%; 高电压:5.7V; 低电压3.7V; ECO阀没有自己的配件号,它与助力泵连在一起. The ECO valve is a component of the power steering pump and permanently connected with the pump.The load from the power steering pump can be regulated back over the valve for consumption optimization in certain engine operating conditions. The delivery volume of the power steering pump varies between 2 - 9 l/min and is adjusted by performance maps, which are stored in the ECU. The actuation takes place with a PWM signal. Duty cycle: 10% - 90% High-level: 5.7 V Low-level: 3.7 V The ECO valve do