11KV出口熔断器的技术协议.doc

ZESCO LIMITED 11 kV DROP OUT FUSE 11kV跌落式熔断器 TECHNICAL SPECIFICATION SCHEDULE A: ZESCO MINIMUM TECHNICAL REQUIREMENTS N/O DETAIL DATA 1 Drop out fuse link assembly (for heavy pollution) complete with fuse carrier and L - brackets See Figure 1 to11 below a) nominal Voltage (Un) r.m.s正常电压 kV 11 2 b) maximum voltage (Um) r.m.s最大电压 KV 12 c) earthing接地 Effective non effective 有或者无 d) Frequency频率 Hz 50 3 Site conditions of service a) altitude海拔 metres 1400 b) Operating Ambient temperature工作环境温度 °C -1 to +40 c) Relative humidity相对湿度 % 85 污染等级 d) Pollution level (as per SABS IEC 60186) Heavy重污染 4 Rating requirements a) nominal voltage正常电压 KV 11 b) current Thermal rating current 热额定电流 fuse carrier熔线座 A 100 Solid link实心连杆 A N/A不要求 Cut out base保险器底座 A 200 5 Electrical components a) Insulator material specification绝缘材料规格 SABS IEC 60273一种标准 Dielectric strength Lightning impulse withstand (1.2/50) 雷电冲击耐受电压 kV 95 Power frequency wet withstand voltage r.m.s工频耐受电压 KV 50 6 creepage distance爬电距离 mm/kV 25 7 General information Drawings: a) Outline and general arrangement 4 COPIES b) Detailed drawings of all items showing critical tolerances To be provide with bid 8 Previous type test report on complete drop out assembly a) Power-frequency voltage wet withstand Bidders to provide previous type test report/results with the bids. b) Lightening impulse voltage withstand c) Current interrupting capacity d) temperature rise e) power frequency wet withstand test f) mechanical strength (endurance). (cutout Base, fuse carrier, and solid link assembly) g) Insulator aging test as per 10 Routine tests (acceptance tests on sample To be provided on delivery Product) 11 Recommended standard PIESA 002 12 Other applicable standards NRS 035 SABS IEC 602