冷凝水管路尺寸计算.doc

The condensate pipe sizing chart The condensate pipe sizing chart (Figure 14.3.5) can be used to size any type of condensate line, including: Drain lines containing no flash steam. Lines consisting of two-phase flow, such as trap discharge lines, which are selected according to the pressures either side of the trap. The chart (Figure 14.3.5): Works around acceptable flash steam velocities of 15 - 20 m/s, according to the pipe size and the proportion of flash steam formed. Can be used with condensate temperatures lower than the steam saturation temperature, as will be the case when using thermostatic steam traps. Is used to size trap discharge lines on full-load conditions. It is not necessary to consider any oversizing factors for start-up load or the removal of non-condensable gases. May also be used to estimate sizes for pumped lines containing condensate below 100°C. This will be discussed in Tutorial 14.4. Fig. 14.3.5 Condensate pipe sizing chart Using the condensate pipe sizing chart (Also available in Appendix 14.3.2) Establish the point where the steam and condensate pressures meet (lower part of the chart, Figure 14.3.5). From this point, move vertically up to the upper chart to meet the required condensate rate. If the discharge line is falling (non-flooded) and the selection is on or between lines, choose the lower line size. If the discharge line is rising, and therefore likely to be flooded, choose the upper line size.Note: The reasoning employed for the sizing of a steam trap is different to that used for a discharge line, and it is perfectly normal for a trap discharge line to be sized different to the trap it is serving. However, when the trap is correctly sized, the usual ancillary equipment associated with a steam trap station, such as isolation valves, strainer, trap testing chamber, and check valve, can be the same size as the trapping device selected, whatever the discharge line size. A steam trap passing a full-load of 1000 kg/h at 6