高速公路毕业设计资料.docVIP

PAGE 1 - 京福线徐州段房亭河—徐庄公路设计 Beijing to fuzhou lines xuzhou section room fangting river - xuzhuang highway design 摘要 摘 要 京福线徐州段是交通部规划的“五纵七横”国道主干线和江苏省“四纵四横四联”高速公路网的重要组成部分。地处淮海经济区域中心，是交通部计划于二十一世纪初建成的重要路段之一。本设计全长9869.264m，双向四车道，路基宽28m，行车道宽3.75m，硬路肩宽3.5m，土路肩宽0.75m，中央分隔带宽3m 本设计进行了路线的选线，横断面设计，纵断面设计，路基设计、挡土墙、涵洞设计、路面结构及路基路面排水设施设计。路面设计中，从经济实用和环境因素的角度进行了充分的考虑，最终选择了沥青混凝土路面。本次设计中基本使用计算机辅助设计与成图，其中路线设计采用纬地软件，路面设计采用HPDS2003A,挡土墙采用纬地软件。同时本设计体现环保意识，强调环保，节约资源。 关键词：高速公路 ；路基路面；线形设计；断面设计；挡土墙设计 Abstract The xuzhou sections of Beijing to fuzhou highway is the ministry of planning five longitudinal and seven horizontal national highway main lines and jiangsu four horizontal quad four lengthwise and an important part of high-speed road network. It is located in huaihai economic area center.It is one of the important section of communications plan built in the twenty-first century, This design full-length is 9869.264m,Two-way four lanes, Subgrade wide 28m, The carriageways wide is 3.75 m, shoulder wide of Hard road is 3.5m, shoulder wide of packway is 0.75m, central dividing strip’s wide is 3m. Design for driving speed is 120km/h . It works by selecting route, cross-sectional design, Cross-sectional design, alignment design, roadbed design, retaining wall, culvert design, Pavement structure and roadbed drainage design. In the process of design pavement Designers fully consider economic and practical and environmental factors, Ultimately chose asphalt concrete pavement. This design basicly use computer aided design and mapping, One route to software design used weft , Pavement design by using HPDS2003A and retaining walls to software weft, Meanwhile, the design reflects the environmental protection consciousness, emphasize environmental protection and resource conservation . Keywords: highway ; roadbed; alignment design ; design of section ; Retaining wal design 目录 目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295912666 第1章 概述 PAGEREF _Toc295912666 \h - 1 - HYPERLINK \l _Toc295912667