instructionsfor vacu vision r f915 hose board assembly（瓦科公司说明r f915软管板组件）.docVIP

Brought to you by M.D. Manufacturing, Inc. (800) 997-2278 Copyright 2012. Instructions for #145VBA VacuVision RF 915 Hose Board Assembly Installation The following guidelines are to assist with the installation of the 145VBA (RF 915 Hose Board Assembly) as a retrofit into Plastiflex 352GH hose handle that previously ONLY used a 110 VOLTAGE WIRE (no low voltage). If you need this technology but don’t have a only 2-wire hose, you can purchase a complete electric RF915 hose. Removal of Hose Board Assembly Unplug hose from any vacuum inlet valve and electrical source. Remove 8 screws on right side of hose handle. Carefully separate the two sides of the hose handle. Remove hose end from stub tube assembly. Be careful to keep rings and separators in place. Remove hose board assembly and stub tube assembly. RF 915 Hose Board Assembly Insertion Insert contact board into slots on the left side of the hose handle. Contact board must be fully seated. Wires should be routed in wire channel and below screw receptacle.  Large black wire should be routed from the contact board to the upper side (right) of main circuit board. Insert the high voltage female receiver into the slots provided on the stub tube end of the hose handle. Route the black and white wire as shown. Position the main circuit board and wires as shown. Yellow RF sending wire should be positioned up towards top of hose handle. The thinner part of the main circuit board should be towards the front of the handle, and the two cylindrical components should be positioned down. Position switch in opening on upper part of handle. Carefully insert stub tube assembly by inserting the two round plastic supports through the associated holes in the main circuit board. Board assembly and stub tube assembly can then be fully seated into hose handle. Check to insure wires are properly routed and not pinched between board and protrusions on handle. Carefully ins