section095400-specialtyceilings-portofportland.docVIP

This master should be used by designers working on Port of Portland construction projects and by designers working for PDX tenants (“Tenants”). Usage notes highlight a few specific editing choices, however the entire section should be evaluated and edited to fit specific project needs. SECTION 095400 – SPECIALTY CEILINGS GENERAL DESCRIPTION This section describes strip, decorative, aluminum linear metal pans and suspension systems for ceilings. REFERENCES ASTM: American Society for Testing and Materials ASTM A641/A641M: Standard Specification for Zinc-Coated (Galvanized) Carbon Steel Wire ASTM C635: Standard Specification for the Manufacture, Performance, and Testing of Metal Suspension Systems for Acoustical Tile and Lay-in Panel Ceilings ASTM E1264: Standard Classification for Acoustical Ceiling Products ASTM E84: Standard Test Method for Surface Burning Characteristics of Building Materials CISCA: Ceilings and Interior Systems Construction Association CISCA Ceiling Systems Handbook IBC: International Building Code NAAMM: National Association of Architectural Metal Manufacturers NAAMM Metal Finishes Manual for Architectural and Metal Products SUBMITTALS Product Data: For each type of product indicated. Performance Data: For installed products indicated to comply with design loads and other criteria, include structural analysis and other analytical data signed and sealed by the qualified professional engineer responsible for their preparation. Samples for Verification: For each component indicated and for each exposed finish required, prepared on samples of size indicated below. Linear Metal Pan: Set of 12-inch-long samples of each type and color and a 12-inch-long spliced section. Suspension System Members: 12-inch-long sample of each type. Exposed Molding and Trim: Set of 12-inch-long samples of each type, finish, and color. Filler Strips: Set of 12-inch-long samples of each type, finish, and color. Sound Absorber: 12 inches long. End Cap: Full size